New items accessories Elbox

26.07.2016

Designers of Remer Production Group continue developing various accessories depending on the requirements of an engineering project.

The following product innovationshave been launched into serial production:

Wall fixing set for EP EP-UMO series cabinets

EP-UMO is intended for the installation of EP and EPV series cabinets on a building wall or other flat surfaces.

Pole fixing set for EP EP-KKC series cabinets

Pole fixing sets for EP-KKC and EP-KKC-45 series cabinets are intended for the installation of EP and EPV series cabinets of 400…600mm wide on round supports with a diameter of 200…350mm.

Double pole fixing set for ShTV-N and EMW EMW-KKC-600  and EMW-KKC-800 series cabinets

The pole fixing set has a reliable and convenient fixing design to put EMW, EMWS and ShTV series cabinets on supports (poles).

Mounting rail 25х45 for EMW/EMWS EMW-RM cabinets

Mounting rail 25х45 for  EMW/EMWS cabinets intend to install the additional equipment to the item on a sidewall surface, base and roofing space.

A set of side angled mounting panels 19" for fixing the EU equipment

A set of angled mounting panels forms a system of 19” standard support structures (482.6 mm), allowing to locate the equipment both vertically and horizontally at various height and depth.

EMW-PCD Cable entry panel

EMW-PCD cable entry panels are designed for the optimization and convenience of cable entry in EMW and EMWS series cabinets and serve to replace the standard solid entry panels.

Mounting rail with a holder for EMS EMS-RM cabinets

It is intended for providing the additional mounting surfaces inside the cabinet with the load capacity of 40 kg and size of 23х23, and the increased load capacity of up to 180 kg and size of 23х73.

Mounting profile for EMS EMS-PRM cabinets

It is intended for providing the additional mounting surfaces inside the cabinet with the load capacity of up to 80 kg and 23х48 size, and with the load capacity of up to 120 kg and 23х73 size.

DIN rail EMS-DIN

DIN rail is intended for fixing various module equipment in EMS series electrical cabinets.

A set of side walls for installing the PF fan for EMS EMS-WF series cabinets

Walls are intended to provide climate control for EMS series cabinets by installing  fans and exhaust filters.  

The roof for mounting the DTT conditioner in EMS EMS-RC series cabinets

The roof is intended to provide climate control for EMS series cabinets by installing conditioners.

Guide rails set for EMS EMS-VG series cabinets

A set is intended for creating a 19-inch mounting space in EMS series cabinets


Back